Tarjetas de desarrollo FPGA

### Alorium Sno

#### Steps
* Solder JTAG and power pins
* Install Quartus Prime Lite Edition
* Install the driver for the USB Blaster
    * Control Panel > Device Manager
    * Search for USB-Blaster
    * Update Driver > Browse > \intelFPGA_lite\18.1\quartus\drivers    
* With Quartus Prime Lite Edition software generate programming file [Assembler]
* Open Quartus Prime Lite Edition
* Go to Tools > Programmer
* Make sure that "USB-Blaster [USB-0]" is selected in Hardware Setup, otherwise click Hardware Setup and in "Currently selected hardware:" select it. Close
* Check the correct FPGA by clicking "Auto Detec" and select 10M16SA
* Click "Add File" and go to the project folder and search and open the programming file, either xxx.sof (lose at powerdown) or xxx.pof
    * project_name/output_files/xxx.pof
* Select <none> file and delete it
* Check the two boxes "Program/Configure" and "Verify" of the main file
* Program the FPGA by clicking "Start"

#### Notes
* *all steps were done using Windows 7
* When using on-chip memory IP cores change configuration mode to "Single Uncompresed Image with Memory Initialization" inside Device>Device and Pin Options...>Configuration mode

Parent page

Comment

Files (Maximum size: 5 MB)

Preview | Cancel

Project

General

Profile

IDI - Instrumentación de radares

Tarjetas de desarrollo FPGA